Piaa RS400 H.I.D. Shock Lamp Manuel d'utilisateur

Shock Lamp RS400 H.I.D.Installation InstructionsThank you very much for purchasing this PIAA product.Please read the entire manual before installation

10NOTES

11

PIAA CORPORATION, USA3004 NE 181st AvenuePortland, Oregon 97230Telephone: 503.489.6666Fax: 503.489.6600Web: www.piaa.comPIAA LIMITED WARRANTYWith the

• When activated, this system operates at extremely high voltage (20,000V). DO NOT turn on the switch when holding the cord that connects the ballast

CONTENTS* Make sure that all parts are in the package. If something is missing, please contact the store where you purchased the product.Philips-hea

4• When using a commercially supplied lamp bracket, before removing the bolt that is already installed on the car body, make sure that it is safe to

When connecting the wires on the harness, follow the wiring diagram and the se-quence below.1. Before connecting any wires, disconnect the negative (

6WIRING DIAGRAM

7DRIVING LIGHT AIMINGTypically, driving lights are mounted above the front bumper about 14-30 inches from the ground to provide extra high beam illumi

8DISASSEMBLY1. Pry white cover o lamp at the arrow location on the black housing.2. Unscrew the black (BK) frame.3. Remove L&R&BK frame u

95. L&R&BK frame unit...6. Unscrew 6 screws on the L&R&BK frame unit and take L&R unit away from the B&K frame. (Note: No